Description
HYDROFIT NSF WATER FILTER HOSE
PT04 – 1/4″ HOSE (500 FT. ROLL) |
|
|---|---|
| Code | Description |
| PT04-BK-0500 | 1/4″ Polyethylene Hose – Black |
| PT04-BL-0500 | 1/4″ Polyethylene Hose – Blue |
| PT04-NA-0500 | 1/4″ Polyethylene Hose – Natural |
PT06 – 3/8″ HOSE (500 FT. ROLL) |
|
|---|---|
| Code | Description |
| PT06-BK-0500 | 3/8″ Polyethylene Hose – Black |
| PT06-BL-0500 | 3/8″ Polyethylene Hose – Blue |
| PT06-NA-0500 | 3/8″ Polyethylene Hose – Natural |
| PT06-WH-0500 | 3/8″ Polyethylene Hose – White |
PT08 – 1/2″ HOSE (250 FT. ROLL) |
|
|---|---|
| Supplier Number | Description |
| PT08-BK-0250 | 1/2″ Polyethylene Hose – Black |
| PT08-BL-0250 | 1/2″ Polyethylene Hose – Blue |
| PT08-NA-0250 | 1/2″ Polyethylene Hose – Natural |
| PT08-WH-0250 | 1/2″ Polyethylene Hose – White |
HDF-TC – HOSE CUTTER |
|
|---|---|
| Supplier Number | Description |
| HDF-TC | Tube Cutter |
Operating Pressure & Temperature Range:
- 1/4″ & 3/8″ 230 PSI @ 70 °F (15 BAR @ 20 °C)Maximum: 120 PSI @ 150 °F (8 BAR @ 65 °C)
- 1/2″ 150 PSI at 70 °F (10 BAR at 20 °C)Maximum: 90 PSI at 150 °F (6 BAR at 65 °C)
Static Pressure – 3 times the maximum pressure or 300 psi minimum.
Burst Pressure – 4 times the maximum pressure or 400 psi minimum
Cyclic Pressure – 100,000 cycles at 150 psi
| HOSE DIAMETER | |
|---|---|
| External Diameter | Inside Diameter |
| 1/4″ | 0.160″ |
| 3/8″ | 0.250″ |
| 1/2″ | 0.37″ |
InstallationInstructions:
STEP 1. CUT THE HOSE
Cut the hose at right angles. Make sure that the hose has a smooth outside diameter with no burrs, chamfers, or other marks before inserting it into the fitting. Hose that has not been cut properly can cause drips and leaks.
STEP 2. INSERT THE HOSE
Push the Hose through the crown and O-Ring until it bottoms out against the quick-connect stop. The crown holds the tube in place and the O-ring provides a leak-resistant seal. If you need to remove the tube always re-cut before reconnecting. Burrs in the pipe can cause leakage.
STEP 3. INSPECT AND TEST
Push and pull the Hose in and out of the Quick Connect Hose to make sure it has been installed correctly. Test and inspect the installation for leaks.
REMOVE THE HOSE
To remove the hose, push the crown of the quick connect against the body while pulling the Hose out of the connection to release it. *Press on the quick CONNECTION in the opposite direction.
