Elkay Wall Mounted Drinking Fountains EZSDL, EZS8L and EZS8S

Elkay wall drinking fountain, with cooling system or for warm water.

Top cover in stainless steel and body in sheet with a Light Gray Granite plastic film or with stainless steel body (EZS8S).

The sprues are designed with lead-free brass parts.

Meets ADA design for adult or child access when properly installed.

Deep sink, minimizes splashing, made in one piece, with integrated drain and easy maintenance.

Flexi-Guard Anti-Microbial Mouthpiece.

Easy to install, due to its universal design it easily adapts to existing plumbing systems.

GENERAL.

Wall hanging kit with electric water cooler. Cooling capacity of 50 ° F potable water, based on 80 ° F and 90 ° F ambient inlet water.

These Elkay models have self-closing Easy-Touch controls on the front and left and right sides.

All models feature Easy-Touch buttons that require less than 3 pounds of force to activate. Patented * valve with built-in flow regulator provides constant flow 20-105 psi of water pressure. Hoses and connections fully protected to comply with all sanitary codes.

Standard non-pressurized stainless steel cooling tank. Non-pressurized water tank is located after the bubble valve, so the tank is subject to line pressure only when the Easy-Touch button is pressed.

Models EZSDL, EZS8L and EZS8S with or without water coolers meet ADA (Americans with Disabilities Act) requirements when installed properly. It also meets child access standards with floor-to-nozzle heights with a height of 30 “or less and sufficient floor clearance for access for maintenance and disassembly (Check state and local codes).

LEAD FREE MATERIALS.

These Elkay drinking fountains are certified and lead free as required by the Drinking Water Act. Elkay manufactures with a piping system that uses copper components and completely lead-free materials. The watercourse has no contact with lead materials, such as leaded brass, have been removed. All joints are soldered using only silver solder. An easy-to-clean grid.

These water coolers are certified to ANSI / NSF61.

COOLING SYSTEM.

Compressor motor: hermetically sealed, voltage 115V single phase 60 Hz. Sealed-for-life reservoir tank. Equipped with electric cable and three-prong rubber plug.

Condenser: The fan and copper tube with aluminum fins. The fan motor is permanently lubricated.

Refrigeration unit: Combination tube-tank type. The tank is made of stainless steel. Fully insulated with EPS foam that meets the requirements of Underwriters Laboratories Inc. for self-extinguishing material. Refrigerant Control: HFC-134a refrigerant is controlled by precisely calibrated capillary tube for trouble-free operation.

Temperature Control: closed adjustable thermostat. Adjusted at the factory. It does not require any adjustments other than for altitude requirements. Easy access.

CONSTRUCTION.

Frame: galvanized steel structural chassis compatible with the cooling system and fastened to the wall. Provides greater structural integrity and stiffness.

Stainless Steel Sink: One piece polished to a uniform, bright luster finish. The sink has an integrated drain grate. There are no exposed bras.

Flexi-Guard® Mouthpiece: Innovative design utilizing a flexible antimicrobial polyester elastomer to prevent accidental mouth injuries. It flexes on impact and returns to its original position. Resistant to abrasion.

Detachable Bottom Cover: An easy piece to remove and replace. Allows access to internal components.

Cabinet: Cabinet with a design that allows installation flush with the wall.

Color Selection: Unless otherwise specified cabinet is sand gray. Also in stainless steel for the EZS8S model.

WARRANTY.

Electricity and chillers: components and water system are warranted for 12 months from the date of installation.

These Elkay kits are designed to operate with 20 psi to 105 psi pressure in the water supply. If the inlet pressure is greater than 105 psi, a pressure regulator must be installed in the supply line. Any damage caused by connecting this product to supply line pressures less than 20 psi or greater than 105 psi is not covered by the warranty. In the electrical parts it does not cover damage due to voltage changes.

MAKER.

Elkay is a supplier of high value commercial plumbing products including water fountains, water coolers, faucets, and repair parts.

WATER PURIFICATION SYSTEM.

This drinker can include a water purifier that works in parallel with an ultraviolet UV sterilizer or an ELKAY model WSP35000 equipment, approved by COFEPRIS anti-bacterial and activated carbon that does not need to be connected to electric light and that complies with the NOM-244-SSA1-2008 standard issued by COFEPRIS, These water filters have been well accepted in the schools in which we have participated, being a comprehensive system used in drinking fountains campaigns for schools and colleges.

UV light lamp as a bactericidal agent.

Protection against bacteria, viruses, E. coli, cryptosporidium, polio, shigella and coloforms. Without the use of chemicals, in 304 stainless steel.

* It is necessary to change the cartridges every 8 to 12 months.

MAINTENANCE.

It is necessary to change the cartridges once a year or when the equipment decreases its flow.

This equipment requires very little maintenance, it is only necessary to periodically clean the sink of the encrustations of salts. In case of severe soiling, you can use an acid for household cleaning or sand the surface of the sink only with a fine sandpaper or fiber that does not cause scratches.