Assembled Johnson Type Nozzle

Assembled lower nozzle with 2 ″ mouth, in 316 stainless steel, for high flows to place on plate or false bottom filters.

Product images are illustrative and may vary from the physical product.

Brand: Carbotecnia
Made of polished 316 Stainless Steel
Connection: 2 ″ bottom opening
Micro-groove opening on the outside: 0.18 mm
Bottom rubber gasket.

Dimentions:
Diameter: 82mm
Groove part height: 50mm
Bottom opening: 50mm
Total height: 150 mm

NOZZLE ASSEMBLED IN STAINLESS STEEL TO BE PLACED ON A PLATE (water nozzles)

Micro-grooved nozzles are used for the retention of granular media in water treatment equipment. These media can be of any type, such as: activated carbon, silica sand, ion exchange resins, green sand, MTM, Birm, pyrolusite, among others.

In addition to the retention function, the micro-grooved nozzles perform a good drainage, as well as an adequate distribution of the flow, both in equipment that works under pressure, as in those that do it by gravity.
The microgroove through which the fluid circulates has a "V" shaped cut, with the most closed part towards the outside of the nozzle. This design prevents plugging.

The microgroove is continuous and has a total flow area approximately twice the section area of the connecting nipple. This means that the microgroove is not a restriction to flow and therefore causes minimal pressure drop.

The 0.18 mm opening in the most closed part, which is the one in contact with the granular medium, allows any granules larger than 40 mesh to be directly retained. This means that no gravel beds are required as support.

Data sheet

Assembled nozzle for false bottom

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

You may also like…